---
name: campervan-build-layout-organizer
description: "Places each living zone in your van relative to the doors and axles, with an ASCII floor plan and three build conflicts to catch before cutting wood. Use when a van builder needs to decide where each zone goes relative to the doors, axles, and cab, with a simple ASCII floor plan. Do not use for costing a build or sequencing the build steps. Related topics: travel, outdoor, campervan."
---

# Campervan Build Layout Organizer

Places each living zone in your van relative to the doors and axles, with an ASCII floor plan and three build conflicts to catch before cutting wood.

## When to use

Use this skill when a van builder needs to decide where each zone goes relative to the doors, axles, and cab, with a simple ASCII floor plan. Do not use it for costing a build or sequencing the build steps.

## Workflow

1. Ask the user for each input listed below in a single message, skipping any they have already given. Where options are listed, offer them, but accept other answers too.
2. Mark the fixed constraints from the van model: doors, wheel arches, axles, and the cab bulkhead.
3. Place the kitchen and wet bath on one side to keep plumbing runs short, and the sleeping area where it fits without blocking doors.
4. Put heavy items between the axles and keep a clear path from each door.
5. Draw an ASCII diagram marking the driver seat, rear entrance, and key furniture, and check it matches the written placement list.
6. State three realistic construction conflicts such as door swing clearance and axle access.

## Inputs

- **Vehicle model** (free text, e.g. "Ford Transit 148 inch")
- **Primary use** (choose one: Solo Camping, Couple Camping, Family Travel, Mobile Office)
- **Must-have zones** (choose any: Kitchen, Sleeping Area, Wet Bath, Storage, Office Desk, Pet Zone)
- **Storage preference** (choose one: Under-bed drawers, Overhead cabinets, Both)
- **Power system** (choose one: 12V only, 12V and mains, Off-grid Solar)

## Output

A short layout summary, a bulleted placement list relative to doors and axles, an ASCII floor plan, and exactly three conflicts to watch for.

## Prompt template

Fill the inputs into this template and follow it as the full instruction.

### Campervan Zone Placement and Floor Plan

Act as a spatial design specialist for compact vehicle interiors. Generate a layout plan for the requested campervan that makes the best use of the available space for living and sleeping.

- Vehicle model: {{Vehicle model}}
- Primary use: {{Primary use}}
- Must-have zones: {{Must-have zones}}
- Storage preference: {{Storage preference}}
- Power system: {{Power system}}

Decide placement from the doors and axles outward: keep the sliding or rear door path clear, put the wet bath and kitchen on the plumbing side, place heavy items between the axles, and keep the bed where its length fits the van's width or length without blocking egress. Place the power equipment where it is both ventilated and reachable.

Start with a brief summary of the layout logic. Then give a bulleted list of each zone's placement relative to the doors and axles. Then draw a simple ASCII diagram marking the driver seat, the rear entrance, and the key furniture. Conclude with three potential conflicts to watch for during construction, such as door swing clearance or axle access.

## Pitfalls

- Blocking the sliding door path with a fixed cabinet or bed.
- Placing the wet bath far from the plumbing side so the water runs become long and awkward.
- An ASCII diagram that disagrees with the written placement list.
